Top kit rig clip | ∅ 2.9 mm max | TKRC029

Can be printed flat on PETG, ABS or even better, TPU substrates.
Filling 100%
Personally, I print in PETG for its strength and flexibility, but also for its relative memory effect.
The only problem with TPU is that after removal, the backing leaves a residue in the rider groove that is difficult to remove.

The only difficulty with this print lies essentially in balancing the parameters of the substrate, which must be dense enough to ensure good quality but at the same time easy to remove to obtain the smoothest possible groove without too much post print work. Not too complicated!