Fiamma Kit Awing Hangers on motorhomes and recreational vehicles.

Description

Unlimited 3D printable and downloadable hook set, consisting of a slide-on clip and an S-hook, for FIAMMA awnings on recreational vehicles. A reinforced design by ApiObi

CLIP:
A mounting clip designed to be inserted and slid into the rail of the front profile (load bar) of the awning on your motorhome, van, or trailer.
With a 6-mm reinforced eyelet for threading the hook.
The part that slides along the rail has a diameter of approximately Ø 5.5 mm and a reinforced octagonal structure
Depending on which side you insert it (front or back), you get two different attachment angles, allowing you to handle a variety of situations (see video below).

S-SHAPED HOOK
The S-hook has an octagonal profile that gives it remarkable strength and makes it easier to print, with the flat side in contact with the build plate. Printed in PETG, it can support a load of several kilograms. Needless to say, these hooks will become some of your essential accessories—useful “must-haves” for both camping and at home.

This set of hooks is ideal for hanging all kinds of items and accessories, such as privacy screens, ropes and tensioners, lights, plants (in my case, herbs), sunshades, clothes and towels to dry, etc.
It is compatible with outdoor awnings from many brands, such as THULE Omnistor & TRISTOR, FIAMMA, and PROSTOR, among others. To be on the safe side, check that your awning's rail has a diameter of 7 mm.
Equivalent to FIAMMA part number: 98655-743

It also serves as a good anchor point for stretching a rope between the awning and a stake driven into the ground to reduce wind resistance.
For this purpose and many others, you can use our rope tensioner clip: