Name: Butt Grip Small 3Dpecheur rod holder | CARP fishing | BGR1
Brand: 3Dpecheur
SKU: 601
Availability: InStock

Butt Grip Small 3Dpecheur rod holder | CARP fishing | BGR1

🆔 DESIGN NO. : 601

⚙︎ Formats : STL

𐊵 Version : 1.0

⦸ No AI - No virus

✏︎ Designer : M@t - apiobi

🗓 Published on: 02/03/2026

💬 Exchanges : 0

3,90 €

Premium quality
Low prices direct from the designer
VAT 0% : VAT not applicable, Art. 293 B of the French General Tax Code
Secure payments

Description

Butt Grip SMALL 3Dpecheur

Excellent grip thanks to large contact area.
Compatible with abbreviated handles
Thread standard 3/8″ (with tolerance adapted to 3D printing).
A design entirely optimized for 3D printing, combined with specific SLICER settings (see below), provides a Butt Grip ultra-resistant, soft, supple and flexible, for excellent rod grip.
The strength of the TPU used far exceeds that of some rubber butt grips on the market. 2 to 3 times more expensive, and sometimes crack or break after the first few uses.

Soft range Butt Grip 3Dpecheur comes in 3 models : SMALL, MEDIUM and LARGE, Our range of products covers the vast majority of needs, from abbreviated handles (SMALL) to Duplon integral or cork handles (LARGE).

See other models in our catalog

Technical Tips for 3D Printing

PRINTING PARAMETERS (TPU)

Nozzle: 0.4 mm
Layer height: 0.12 mm for increased pitch accuracy.

Infill :
Tip: Butt Grip requires two separate fillings:

40-45 % gyroid for the body (adjust according to the hardness and quality of your TPU).

In Cura, minimum 14 mm block, including thread pitch + 2 mm extra, to be printed in 100 % infill to guarantee rigidity and strength at thread level.

Filament: TPU only.

Slicer :
Vertical orientation, no screws upwards, with brackets and ceiling brackets.
Caution: don't use too high a percentage of ceiling brackets - TPU brackets that are too dense become very difficult to remove cleanly.

Application of a scaling factor: Impossible.
Post-treatment / finishing: None required.